206-00-22 Brake System — General Information 206-00-22
GENERAL PROCEDURES (CONTINUED)
E4252 EN 07/2001 2002 Bantam
5. If the bush is worn or damaged remove it from
the axle tube bracket and replace it.
Installation
1. If the bush requires replacement (step 5
above), fit a new bush by coiling the bush and
pressing it into the aperture in the bracket.
2. Apply a small smear of grease to the axle end
of the link rod and a liberal amount of grease
to the other end. Slide the link rod into the
axle bracket bush.
3. Slide the spacer tube assembly over the link
rod and refit the valve to the body bracket,
secure with two bolts.
4. Reconnect the brake pipes.
5. Bleed the brakes, refer to Section 206-00-21
Note: Ensure that the valve is kept "open" (valve
actuating lever hard against valve body) dur-
ing operation, by using a suitable clip or wire.
Ensure that the vale is not damaged.
6. Adjust the valve linkage.
To Next Page
Loading...
