206-00-26 Brake System — General Information 206-00-26
GENERAL PROCEDURES (CONTINUED)
E3166 EN 07/2001 2002 Bantam
8. Check the brake disc thickness variation.
• Using a suitable Micrometer measure
the disc thickness at eight positions 45°
apart and 15 mm in from the outer edge of
the brake disc.
• If any of the readings vary by 0.015 mm
or more, or the brake disc thickness is
less than the specified minimum, a new
brake disc should be installed.
9. Remove the brake disc. For additional
information, refer to Section 206-03
refer to Section 206-04.
10. NOTE: Make sure the wheel hub face is
clean and free of rust and foreign material.
Using the special tool, check the wheel hub
face run out.
• Slowly rotate the wheel hub and check
the run out. If the run out exceeds the
given specification. Install a new wheel
hub and recheck. For additional
information, refer to Section 204-01.
11. If the hub face run out is within specification
install a new brake disc and recheck the
brake disc run-out. For additional
information, refer to Section 206-03
refer to Section 206-04.
To Next Page
Loading...
