206-03-10 Front Disc Brake 206-03-10
DISASSEMBLY AND ASSEMBLY (CONTINUED)
E9361 EN 03/2001 2002 Bantam
4.
CAUTION: Do not use a screwdriver or
any other similar tool to pry the brake
caliper piston seal out of the brake
caliper bore.
Remove the brake caliper piston seal.
• Discard the seal.
Assembly
WARNING: Install a new brake caliper
piston if rust, pitting or scores are evi-
dent. Failure to follow these instructions
may result in personal injury.
WARNING: Install a new brake caliper if
rust, pitting or scores are evident in the
brake caliper bore. Failure to follow
these instructions may result in per-
sonal injury.
NOTE: Install a new brake caliper piston seal
and a new brake caliper dust seal.
NOTE: Lubricate the piston, piston bore and pis-
ton seal with Super DOT 4 brake fluid prior to
installation.
1. To assemble, reverse the disassembly
procedure.
To Next Page
Loading...
