303-01B-73 Engine — 1.6L / 1.3L RoCam 303-01B-73
IN-VEHICLE REPAIR (CONTINUED)
E6641 EN 07/2001 2002 Bantam
Installation
All vehicles
1. Preparatory operations
NOTE:
Do not damage the mating faces.
• Using a spatula or scraper remove any
traces of sealer or gasket residue from the
mating faces.
NOTE: The mating faces must be free of oil and
gasket residue.
• Clean the oil pan to remove any oil
residue or sludge.
2. NOTE:
Apply a 3 to 5 mm bead of sealer
(LOCTITE 5910) to the marked areas.
NOTE:
Install the oil pan within 5 minutes of
applying the sealer beads.
Using a straightedge, align the oil pan flush
to the rear cylinder block surface.
• Wait no longer than 5 minutes to install
the oil pan gasket.
3. Install and tighten the oil pan retaining bolts
(stage 1).
4. Tighten the oil pan retaining bolts (stage 2).
To Next Page
Loading...
