Pinpoint Tests
NOTE: These Pinpoint Tests are designed to
take the technician through a step-by-step
diagnosis procedure to determine the cause of a
condition. It may not always be necessary to
follow the chart to its conclusion. Perform only
the Pinpoint Test Steps necessary to correct the
condition. Then check operation of the system to
make sure the condition has been corrected.
After verifying that the condition has been
corrected, make sure all components removed
have been installed.
100-04-41B Noise, Vibration and Harshness 100-04-41B
E859 EN 02/2001 2002 Bantam
To Next Page
Loading...
