303-01B-105 Engine — 1.6L / 1.3L RoCam 303-01B-105
ASSEMBLY (CONTINUED)
E6645 EN 07/2001 2002 Bantam
5. Measure the piston ring end gaps. For
additional information, refer to Section 303-
00.
6. Check the cylinder head for distortion. For
additional information, refer to Section 303-
00.
7. NOTE:
The oil grooves on the thrust half
washers must be visible.
Install the main bearing shells.
1. Insert the main bearing shells.
2. Insert the thrust half washers into the
center main bearing.
8. NOTE:
The bearing cap numbering starts at
the timing chain end, to which the arrows also
point.
Install the crankshaft.
1. Lubricate the main bearing journals and
bearing shells with engine oil.
2. Install the crankshaft main bearing caps
with their associated bearing shells.
3. Tighten the bolts.
4. Make sure that the crankshaft is in TDC
cylinder No. 1 position.
To Next Page
Loading...
