Ford 2002 Bantam - Page 51

100-04-47 Noise, Vibration and Harshness 100-04-47
DIAGNOSIS AND TESTING (CONTINUED)
E859 EN 02/2001 2002 Bantam
CONDITIONS
DETAILS/RESULTS/ACTIONS
E2: BALANCE THE WHEELS
1 Balance the wheels. REFER to Section 204-
03.
- Balance the wheels and install on the vehicle.
• Does the vehicle function correctly?
 Yes
Condition corrected.
 No
GO TO E3
E3: ROTATE THE WHEELS
1 Rotate the wheels. REFER to Section 204-03.
- Rotate the wheels front to rear, and rear to
front.
• Does the vehicle function correctly?
 Yes
Condition corrected.
 No
GO TO E4
E4: CHECK THE RUN OUT
1 Check the run out. REFER to Section 204-03.
- Check total radial run out and total lateral run
out of the wheel.
• Is the run out less than 1.01 mm for the front
wheels and less than 1.187 mm for the rear
wheels?
 Yes
GO TO E5
 No
GO TO E6
E5: CHECK THE TYRE MOUNT ON THE WHEEL
1 Check the tyre mount on the wheel.
- Check the total radial run out again as
outlined in Pinpoint Test E4.
• Is the total radial run out less than 1.01 mm?
 Yes
GO TO E6
 No
INSTALL new tyre(s) as necessary. TEST
the system for normal operation.