303-01D-53 Engine — 1.8L Diesel - Endura DE 303-01D-53
IN-VEHICLE REPAIR (CONTINUED)
E6346 EN 09/2001 2002 Bantam
17. Turn the crankshaft to the TDC position.
• Remove the blanking plug from the
cylinder block.
NOTE: The alignment pin must be screwed in
as far as it will go.
• Screw in the timing pin.
• Carefully turn the crankshaft in the
normal direction of rotation of the engine
until it comes up against the timing pin.
18. Lower the vehicle.
19. Insert the alignment pin into the camshaft
timing belt pulley.
20. Slacken the bolts of the camshaft timing
belt pulley.
21. Remove the camshaft timing belt.
1. Slacken the clamp bolt of the timing belt
tensioner.
2. Slacken the timing belt by compressing
the spring using water pump pliers.
• Tighten the clamp bolt of the timing belt
tensioner.
• Remove the timing belt.
To Next Page
Loading...
