EasyManua.ls Logo

Ford 2002 Bantam - Page 66

Ford 2002 Bantam
1663 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
204-00-5 Suspension General Information 204-00-5
DIAGNOSIS AND TESTING (CONTINUED)
E1049 EN 06/2001 2002 Bantam
Condition
Possible Sources
Action
Steering gear or tie-rods worn or
damaged.
CHECK the steering system.
REFER to Section 211-00.
Worn, damaged or defective
tyre(s).
INSPECT the tyres.
REFER to Section 204-03.
• Hard steering
Excessive positive caster angle.
CARRY OUT wheel alignment.
Refer to General procedures in
this section.
Vehicle ride height incorrect
(front or rear, high or low).
CHECK for abnormal loading,
spring sag or non-standard
springs.
Steering gear or tie-rods worn or
damaged.
CHECK the steering system.
REFER to Section 211-00.
Front suspension lower arm ball
joint worn or damaged.
REFER to the Service
Procedures in this section.
Damaged tyres or unbalanced
wheels.
CHECK the tyres.
REFER to Section 204-03.
Insufficient power steering as-
sist.
CHECK the power steering sys-
tem. REFER to Section 211-02.
• Brake pull • Unequal tyre pressures. INFLATE the tyres to the correct
pressures.
REFER to Section 204-03.
• Brake system failure. CHECK the brakes.
REFER to Section 206-00.
Shimmy or vibration Wheel tyre imbalance, damage
or excessive run out.
CHECK the tyres.
REFER to Section 204-03.
Front wheel driveshaft(s) worn
or damaged.
CHECK the front wheel Half-
shafts.
REFER to Section 205-04.
Steering system damaged or
worn.
CHECK the steering system.
REFER to Section 211-00.
Suspension unit assembly
loose, worn or damaged.
CHECK the suspension unit as-
semblies.
Loose suspension unit assembly
mounting.
TIGHTEN components to speci-
fication.
REFER to Section 204-01. (front).
REFER to Section 204-02. (rear).
Damaged or worn front suspen-
sion lower arm ball joint.
INSTALL a new front suspen-
sion lower arm ball joint.
REFER to Section 204-01.
Damaged, loose or worn front
suspension lower arm mounting
bolt bushing.
INSTALL a new front suspen-
sion lower arm mounting bolt
bushing.
REFER to Section 204-01.
Refer to the procedure in
this section

Table of Contents

Related product manuals