303-01D-166 Engine — 1.8L Diesel - Endura DE 303-01D-166
GENERAL PROCEDURES (CONTINUED)
E5885 EN 09/2001 2002 Bantam
4. Check the valve clearances.
• Turn the crankshaft until the two cams of
the cylinder to be checked face evenly
upwards.
• Check the valve clearances with a feeler
gauge and rectify as necessary by
changing the shims as described in step
5. NOTE: Turn the crankshaft further through
approx. 90 degrees. The piston of the
cylinder that is to be adjusted must not be at
TDC.
NOTE: The lettering on the valve shims faces
downwards.
Change the valve shims.
1. Press down the two valve tappets
simultaneously.
2. Change the valve shims.
6. Fit the oil baffle.
7. Seal the parting line between the bearing
cap and the cylinder head on both sides
with a thin bead of sealer (SPM-4G9112-
F/G).
To Next Page
Loading...
