303-06-202 Starting System 303-06-202
DIAGNOSIS AND TESTING
E1017 EN 09/2001 2002 Bantam
Starting System
Inspection and Verification
WARNING: When performing engine
compartment work near the starter, be
aware that the heavy gauge battery input
lead to the starter is electrically hot at all
times.
1. Verify the customer concern.
2. Check for concerns with the following.
Visual Inspection Chart
Mechanical
Electrical
• Starter motor
• Battery
• Fuse
• Wiring
• Connectors
3. If inspection reveals an obvious cause rectify
this before continuing. If the concern
remains, proceed to the symptom chart.
Symptom Chart
Symptom Chart
Condition
Possible Sources
Action
• The engine does not crank relay
clicks
• Battery
• Circuits
• Starter motor
• GO to Pinpoint Test A
• The engine cranks slowly • Battery
• Circuits
• Starter motor
• GO to Pinpoint Test B
• Unusual starter noise • Starter motor
• Ring gear
• GO to Pinpoint Test C
• Starter motor spins but engine
does not crank
• Solenoid • GO to Pinpoint Test D
To Next Page
Loading...
