303-04D-17 Fuel Charging and Controls — 1.8L Diesel Engine 303-04D-17
REMOVAL AND INSTALLATION (CONTINUED)
E6448 EN 09/2001 2002 Bantam
39. Remove the special tool from the fuel
injection pump.
40. Remove the fuel injection pump pulley.
41. Raise and support the vehicle. For
additional information,
refer to Section 100-02.
42. Remove the three bolts which retain the
fuel injection pump rear support bracket to
the cylinder block.
43. Lower the vehicle.
44. CAUTION: Before removing
the three bolts which retain the fuel
injection pump to the front cover, make
sure that the fuel injection pump is
adequately supported.
Remove the fuel injection pump.
45. Remove the fuel injection pump from the
rear support bracket.
To Next Page
Loading...
