303-14-248 Electronic Engine Controls 303-14-248
REMOVAL AND INSTALLATION (CONTINUED)
5. Install the engine undershield.
6. Lower the vehicle.
7. Connect the PCM and CMP electrical
connectors.
8. Install the hoses and connect the electrical
connector.
1. EVAP solenoid valve vacuum hose.
2. PCV hose.
3. Crankcase breather hose.
4. ECT sensor electrical connector.
5. Brake booster vacuum hose.
9. Install the accelerator cable.
1. Connect the inner cable.
2. Install the cable into the retaining
bracket, check the cable setting and
secure using the clip.
To Next Page
Loading...
