308-00-13 Manual Transaxle and Clutch — General Information 308-00-13
DIAGNOSIS AND TESTING (CONTINUED)
E6760 EN 07/2001 2002 Bantam
PINPOINT TEST G: EXCESSIVE NOISE
CONDITIONS
DETAILS/RESULTS/ACTIONS
G1: CHECK THE TRANSAXLE NEUTRAL POSITION
1.
2 Start the engine and run it in NEUTRAL.
3 Depress the clutch pedal fully.
• Are there noises when the clutch is operated?
Yes
GO TO G2
No
There is a problem with the transaxle.
REFER to Symptom Chart(s).
G2: TEST THE CLUTCH PEDAL FREE TRAVEL
1 Depress the clutch down manually until resis-
tance is felt, then release it again.
2 Measure the pedal travel.
• Is the travel within 10 mm?
Yes
GO TO G3
No
REFER to the Clutch Master Cylinder
Gen
eral procedure in this section.
G3: CHECK THE CLUTCH SLAVE CYLINDER WITH RELEASE BEARING
1 Remove the transaxle.
REFER to Section 308-
03.
2 Check the clutch slave cylinder bolts.
3 Check the release bearing for wear and rust.
• Are the bolts loose or are there signs of wear
or rust?
Yes
TIGHTEN the bolts or install a new clutch
slave cylinder with the release bearing.
TEST the system for normal operation.
No
GO TO G4
To Next Page
Loading...
