308-00-22 Manual Transaxle and Clutch — General Information 308-00-22
GENERAL PROCEDURES (CONTINUED)
E6761 EN 07/2001 2002 Bantam
5. Remove the gearshift mechanism shift rod
and stabilizer.
1. Remove the shift rod
2. Remove the gearshift stabilizer bar.
6. Adjust the gearshift mechanism.
• Engage fourth gear (starting with the
selector shaft in the neutral position).
• Using 9 mm diameter drill bit, lock the
gearshift lever in fourth gear position.
7. NOTE: If the gearshift stabilizer cannot be
installed, loosen the engine and transaxle
mounting.
Install the gearshift stabilizer and the shift
rod.
1. Install the shift rod.
2. Install the gearshift stabilizer.
8. Tighten the engine and transaxle mounting
(as necessary). For additional information,
refer to Section 303-01A.
9. Install the exhaust heat shield.
To Next Page
Loading...
