308-02-36 Clutch Controls 308-02-36
REMOVAL AND INSTALLATION (CONTINUED)
E6711 EN 07/2001
4. Remove the snap rings and move clutch
pedal approximately 15 mm sidewards.
1. Remove the pedal mounting
2. Remove the piston clutch rod master
cylinder
• Move the pedal approximately 15 mm
sidewards.
5. Remove the clutch master cylinder.
1. Remove the two bolts.
2. Pull the piston rod from the clutch pedal
and remove the clutch master cylinder.
Installation
1. To install, reverse the removal procedure
2. Top up the brake fluid reservoir. For
additional information,
refer to Section 206-
06.
3. Bleed the clutch system. For additional
information,
refer to Section 308-00.
4. Connect the battery ground cable. For
additional information,
refer to Section 414-
01.
To Next Page
Loading...
