308-03-71 Manual Transaxle 308-03-71
DISASSEMBLY (CONTINUED)
E1162 EN 07/2001
18. Remove the differential assembly, the
permanent magnet and the input shaft oil
seal.
1. Take off the housing gasket.
2. Lift out the differential assembly.
3. Permanent magnet
4. Drive out the drive halfshaft oil seal.
19. Remove the output shaft taper roller
bearing.
1. Press the rollers out of the bearing cage.
2. Remove the bearing cage.
20. CAUTION: Use the special tool only
in the position shown, otherwise the
blanking plug will be pushed out of
the housing.
Remove the output shaft bearing cone.
• Remove the oil slinger.
21. NOTE: Position the special tool in the
cutouts in the housing.
Remove the differential bearing cone.
To Next Page
Loading...
