308-03-76 Manual Transaxle 308-03-76
DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIES
E1164 EN 07/2001
Input Shaft (16 146 5)
Special Tool(s)
Installer
308-045 (16-015)
General Equipment
Puller
Press
Material
Specification
Transmission fluid BOT 130
Disassembly
CAUTION: Handle synchronizer rings
and cones with care.
1. Pull off the ball bearing on the transmission
end.
1. Fit the snap-ring.
2. Engage a proprietary puller under the
snap-ring and pull off the ball bearing.
2. Pull off the ball bearing on the clutch end.
Assembly
1. Carefully clean and check all parts and coat
with transmission fluid before assembling.
To Next Page
Loading...
