1-10
Description
Use the display ip routing-table protocol command to display routing information of a specified
routing protocol.
Examples
# Display brief information about direct routes.
<Sysname> display ip routing-table protocol direct
Public Routing Table : Direct
Summary Count : 6
Direct Routing table Status : < Active>
Summary Count : 6
Destination/Mask Proto Pre Cost NextHop Interface
2.2.2.0/24 Direct 0 0 2.2.2.1 Vlan2
2.2.2.2/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
192.168.80.0/24 Direct 0 0 192.168.80.10 Vlan1
192.168.80.10/32 Direct 0 0 127.0.0.1 InLoop0
Direct Routing table Status : < Inactive>
Summary Count : 0
# Display brief information about static routes.
<Sysname> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 2
Static Routing table Status : < Active>
Summary Count : 0
Static Routing table Status : < Inactive>
Summary Count : 2
Destination/Mask Proto Pre Cost NextHop Interface
1.2.3.0/24 Static 60 0 1.2.4.5 Vlan10
3.0.0.0/8 Static 60 0 2.2.2.2 Vlan1
For detailed description of the above output, see Table 1-1.
display ip routing-table statistics
Syntax
display ip routing-table statistics
View
Any view
To Next Page
Loading...
Need help?
General