1-4
Description
Use the ip route-static default-preference command to configure the default preference for static
routes.
Use the undo ip route-static default-preference command to restore the default.
By default, the default preference of static routes is 60.
Note that:
z If no preference is specified when configuring a static route, the default preference is used.
z When the default preference is re-configured, it applies to newly added static routes only.
Related commands: ip route-static and display ip routing-table in IP Routing Basics Commands.
Examples
# Set the default preference of static routes to 120.
<Sysname> system-view
[Sysname] ip route-static default-preference 120
To Next Page
Loading...
Need help?
General