2-3
View
Multicast VLAN view
Default Level
2: System level
Parameters
interface-list: Specifies a port in the form of interface-type interface-number, or a port range in the form
of interface-type start-interface-number to interface-type end-interface-number, where the end
interface number must be greater than the start interface number.
all: Deletes all the ports in the current multicast VLAN.
Description
Use the port command to assign the specified port(s) to the current multicast VLAN.
Use the undo port command to delete the specified port(s) or all ports from the current multicast VLAN.
By default, a multicast VLAN has no ports.
Note that:
z A port can belong to only one multicast VLAN.
z Only the following types of interfaces can be configured as multicast VLAN ports: Ethernet, or
Layer 2 aggregate interfaces.
Examples
# Assign ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5 to multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan 100
[Sysname-mvlan-100] port gigabitethernet 1/0/1 to gigabitethernet 1/0/5
port multicast-vlan
Syntax
port multicast-vlan vlan-id
undo port multicast-vlan
View
Ethernet interface view, Layer 2 aggregate interface view, port group view.
Default Level
2: System level
Parameters
vlan-id: VLAN ID of the multicast VLAN you want to assign the current port(s) to, in the range of 1 to
4094.
Description
Use the port multicast-vlan command to assign the current port(s) to the specified multicast VLAN.
To Next Page
Loading...
Need help?
General