H3C S5120-SI Series Command Reference

1-3
Parameters
None
Description
Use the display info-center command to display the information of each output destination.
Examples
# Display configurations on each output destination.
<Sysname> display info-center
Information Center:enabled
Log host:
1.1.1.1, port number : 514, host facility : local2,
channel number : 8, channel name : channel8
Console:
channel number : 0, channel name : console
Monitor:
channel number : 1, channel name : monitor
SNMP Agent:
channel number : 5, channel name : snmpagent
Log buffer:
enabled,max buffer size 1024, current buffer size 512,
current messages 512, dropped messages 0, overwritten messages 740
channel number : 4, channel name : logbuffer
Trap buffer:
enabled,max buffer size 1024, current buffer size 256,
current messages 216, dropped messages 0, overwritten messages 0
channel number : 3, channel name : trapbuffer
logfile:
channel number:9, channel name:channel9
syslog:
channel number:6, channel name:channel6
Information timestamp setting:
log - date, trap - date, debug - date,
loghost - date
Table 1-3 display info-center command output description
Field Description
Information Center
The current state of the information center, which
could be enabled or disabled.
Log host:
1.1.1.1, port number : 514, host facility :
local2,
channel number : 8, channel name : channel8
Configurations on the log host destination (It can
be displayed only when the info-center loghost
command is configured), including IP address of
the log host, number of the port that receives the
system information on the log host, logging
facility used, and the channel number and
channel name used.)

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English