1-1
1 MAC Address Table Configuration Commands
Currently, interfaces involved in MAC address table configuration can only be Layer 2 Ethernet ports
and Layer 2 aggregate interfaces.
MAC Address Table Configuration Commands
display mac-address
Syntax
display mac-address [ mac-address [ vlan vlan-id ] | [ [ dynamic | static ] [ interface interface-type
interface-number ] | blackhole ] [ vlan vlan-id ] [ count ] ]
View
Any view
Default Level
1: Monitor level
Parameters
blackhole: Destination blackhole MAC address entries. These entries do not age but you can add
or remove them. Packets whose destination MAC addresses match destination blackhole MAC
address entries are dropped.
vlan vlan-id: Displays MAC address entries of the specified VLAN, where vlan-id is in the range 1 to
4094.
count: Displays the number of MAC address entries specified by related parameters in the command.
When this keyword is used, the command displays only the number of specified MAC address entries,
rather than related information about these MAC address entries.
mac-address: Displays MAC address entries in a specified MAC address, in the format of H-H-H.
dynamic: Displays dynamic MAC address entries. Aging time is set for these entries.
static: Displays static MAC address entries. Similar to blackhole MAC address entries, these entries do
not age but you can add or remove them.
interface interface-type interface-number: Displays MAC address learning status of the specified
interface. interface-type interface-number specifies an interface by its type and number.
To Next Page
Loading...
Need help?
General