Hirschmann RS20

CLI Commands: Base
110
4.6 Management Commands
CLI L2P
Release 7.0 05/2011
4.6.17 show digital-input all
This command shows the IO-Module value or configuration for all inputs.
Format
show digital-input all {all | config | value}
Mode
Global Config
all
Show the IO-Module configuration and value for all inputs
config
Show the IO-Module configuration for all inputs.
value
Show the IO-Module value for all inputs.
Digital Input Information:
Input
Show numbers of the IO-Module digital input.
Possible values (example): 1/1, 1/2, 1/3, 1/4,
3/1, 3/2, 3/3, 3/4
Value
Show the value of the IO-Module digital inputs.
Possible values: Not available, High, Low.
Log-Event
Show if Event logging is enabled or disabled for the IO-Module digital
inputs. Possible values: Disabled, Enabled.
SNMP-trap
Show if SNMP traps are enabled or disabled for the IO-Module digital
inputs. Possible values: Disabled, Enabled.