CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
121
4.6.30 network parms
This command sets the IP Address, subnet mask and gateway of the router.
The IP Address and the gateway must be on the same subnet.
Format
network parms <ipaddr> <netmask> [gateway]
Mode
Privileged EXEC
4.6.31 network protocol
This command specifies the network configuration protocol to be used.
If you modify this value, change is effective immediately after you saved your
changes.
The parameter bootp indicates that the switch periodically sends requests
to a Bootstrap Protocol (BootP) server or a DHCP server until a response is
received.
none indicates that the switch should be manually configured with IP infor-
mation.
Independently of the BootP and DHCP settings, HiDiscovery can be
configured as an additional protocol.
Default
DHCP
Format
network protocol {none | bootp | dhcp | hidiscovery
{off | read-only | read-write}}
Mode
Privileged EXEC
To Next Page
Loading...
