Hirschmann RS20 Reference Manual

CLI L2P
Release 7.0 05/2011
4.10 User Account Management Commands
269
4.10.3 show users
This command displays the configured user names and their settings. This
command is only available for users with readwrite privileges. The SNMPv3
fields will only be displayed if SNMP is available on the system.
Format
show users
Mode
Privileged EXEC
User Name
The name the user will use to login using the serial port, Telnet or
Web. A new user may be added to the switch by entering a name in a
blank entry. The user name may be up to eight characters, and is not
case sensitive. Two users are included as the factory default, ‘admin’
and ‘user’
Access Mode
Shows whether the operator is able to change parameters on the
switch (Read/Write) or is only able to view them (Read Only). As a
factory default, the ‘admin’ user has Read/Write access and the ‘user’
has Read Only access. There can only be one Read/Write user and
up to five Read Only users.
SNMPv3 AccessMode
This field displays the SNMPv3 Access Mode. If the value is set to
ReadWrite, the SNMPv3 user will be able to set and retrieve parame-
ters on the system. If the value is set to ReadOnly, the SNMPv3 user
will only be able to retrieve parameter information. The SNMPv3
access mode may be different than the CLI and Web access mode.
SNMPv3 Authentication
This field displays the authentication protocol to be used for the spec-
ified login user.
SNMPv3 Encryption
This field displays the encryption protocol to be used for the specified
login user.

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16