EasyManua.ls Logo

Hirschmann RS20

Hirschmann RS20
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CLI L2P
Release
7.0
05/2011
4.9
Device Configuration Commands
197
4.9.34 set gmrp interfacemode
This command enables GARP Multicast Registration Protocol on a selected
interface. If an interface which has GARP enabled is enlisted as a member
of a Link Aggregation (LAG), GARP functionality will be disabled on that in-
terface. GARP functionality will subsequently be re-enabled if Link Aggrega-
tion (LAG) membership is removed from an interface that has GARP
enabled.
Default
enabled
Format
set gmrp interfacemode
Mode
Interface Config
U no set gmrp interfacemode
This command disables GARP Multicast Registration Protocol on a
selected interface. If an interface which has GARP enabled is enlisted as
a member of a Link Aggregation (LAG), GARP functionality will be dis-
abled on that interface. GARP functionality will subsequently be re-
enabled if Link Aggregation (LAG) membership is removed from an inter-
face that has GARP enabled.
Format
no set gmrp interfacemode
Mode
Interface Config

Table of Contents

Other manuals for Hirschmann RS20

Related product manuals