CLI Commands: Switching
CLI L2P
Release
7.0
05/2011
5.1
Spanning Tree Commands
413
5.1.15 spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value.
The Force Protocol Version can be one of the following:
D 802.1d - ST BPDUs are transmitted
(802.1Q-2005 functionality supported)
D 802.1s - ST BPDUs are transmitted
(802.1Q-2005 functionality supported)
D 802.1w - RST BPDUs are transmitted
(802.1Q-2005 functionality supported)
Default
802.1w
Format
spanning-tree forceversion
<802.1d | 802.1s | 802.1w>
Mode
Global Config
U no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default
value, i.e. 802.1w.
Format
no spanning-tree forceversion
Mode
Global Config
To Next Page
Loading...
