Hirschmann RS20 Reference Manual

CLI Commands: Switching
424
5.1 Spanning Tree Commands
CLI L2P
Release 7.0 05/2011
5.1.25 spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree in-
stance. The instance <mstid> is a number that corresponds to the desired ex-
isting multiple spanning tree instance. The priority value is a number within a
range of 0 to 61440 in increments of 4096.
This command accepts the value 0 for the mstid.
If 0 (defined as the default CIST ID) is passed as the <mstid>, then this
command sets the Bridge Priority parameter to a new value for the common
and internal spanning tree. The bridge priority value again is a number within
a range of 0 to 61440. The twelve least significant bits will be masked
according to the 802.1s specification. This will cause the priority to be
rounded down to the next lower valid priority.
Default
32768
Format
spanning-tree mst priority <mstid> <0-61440>
Mode
Global Config
U no spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning
tree instance to the default value, i.e. 32768. The instance <mstid> is a
number that corresponds to the desired existing multiple spanning tree
instance.
This command accepts the value 0 for the mstid.
If 0 (defined as the default CIST ID) is passed as the <mstid>, then this
command sets the Bridge Priority parameter for the common and internal
spanning tree to the default value, i.e. 32768.
Format
spanning-tree mst priority <mstid>
Mode
Global Config

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16