Hirschmann RS20 Reference Manual

CLI Commands: Security
504
6.1 Security Commands
CLI L2P
Release 7.0 05/2011
6.1.14 dot1x port-control all
This command sets the authentication mode to be used on all ports. The
control mode may be one of the following.
D force-unauthorized: The authenticator PAE unconditionally sets the
controlled port to unauthorized. Thus the ports are always blocked.
D force-authorized: The authenticator PAE unconditionally sets the
controlled port to authorized. Thus the ports are always opend.
D auto: The authenticator PAE sets the controlled port mode to reflect the
outcome of the authentication exchanges between the supplicant,
authenticator and the authentication server. The port mode is controled by
the protocol.
D mac-based: Enable the MAC-based 802.1X authentication on the port.
Default
force-authorized
Format
dot1x port-control all {force-unauthorized | force-
authorized | auto |mac-based}
Mode
Global Config
U no dot1x port-control all
This command sets the port-control mode for all the ports to the default
mode (force-authorized).
Format
no dot1x port-control all
Mode
Global Config

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16