CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
149
4.6.64 snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a
Multiple User Trap is sent when a user logs in to the terminal interface (EIA
232 (serial port) or telnet) and there is an existing terminal interface session.
Default
enabled
Format
snmp-server enable traps multiusers
Mode
Global Config
U no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format
no snmp-server enable traps multiusers
Mode
Global Config
To Next Page
Loading...
