Hirschmann RS20 Reference Manual

CLI Commands: Base
72
4.1 System Information and Statistics Com-
CLI L2P
Release 7.0 05/2011
4.1.22 show running-config
This command is used to display the current setting of different protocol
packages supported on the switch. This command displays only those
parameters, the values of which differ from default value. The output is
displayed in the script format, which can be used to configure another switch
with the same configuration.
Format
show running-config [all | <scriptname>]
Mode
Privileged EXEC
all
Show all the running configuration on the switch. All configuration
parameters will be output even if their value is the default value.
<scriptname>
Script file name for writing active configuration.
Note: file extension must be .cli, file name must not exceed 16
characters, must not start with a dot (.) and must not contain a
directory.

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16