CLI L2P
Release
7.0
05/2011
4.12
LLDP - Link Layer Discovery Protocol
321
4.12.26lldp admin-state
Configure the port's LLDP admin state (if LLDP/IEEE802.1AB frames will be
transmitted to and/or received from the standard IEEE multicast address
01:80:c2:00:00:0e).
The default setting is tx-and-rx.
Format
lldp admin-state <{tx-only|rx-only|tx-and-rx|off}>
Mode
Interface Config
4.12.27lldp fdb-mode
Configure the port's LLDP FDB mode.
The default setting is autodetect.
Format
lldp fdb-mode <{lldp-only|mac-only|lldp-and-
mac|autodetect}>
Mode
Interface Config
To Next Page
Loading...
