Mode-based CLI
CLI L2P
Release
7.0
05/2011
3.2
Mode-based Command Hierarchy
43
3.2 Mode-based Command
Hierarchy
The CLI is divided into various modes. The Commands in one mode are not
available until the operator switches to that particular mode, with the excep-
tion of the User Exec mode commands. The User Exec mode commands
may also be executed in the Privileged Exec mode.
The commands available to the operator at any point in time depend upon
the mode. Entering a question mark (?) at the CLI prompt, displays a list of
the available commands and descriptions of the commands.
The CLI provides the following modes:
User Exec Mode
When the operator logs into the CLI, the User Exec mode is the initial
mode. The User Exec mode contains a limited set of commands. The
command prompt shown at this level is:
Command Prompt: (Hirschmann Product)>
Privileged Exec Mode
To have access to the full suite of commands, the operator must enter
the Privileged Exec mode. Privileged users authenticated by login are
able to enter the Privileged EXEC mode. From Privileged Exec mode,
the operator can issue any Exec command, enter the VLAN mode or
enter the Global Configuration mode . The command prompt shown
at this level is:
Command Prompt: (Hirschmann Product)#
VLAN Mode
This mode groups all the commands pertaining to VLANs. The com-
mand prompt shown at this level is:
Command Prompt: (Hirschmann Product)(VLAN)#
Global Config Mode
This mode permits the operator to make modifications to the running
configuration. General setup commands are grouped in this mode.
From the Global Configuration mode, the operator can enter the Sys-
tem Configuration mode, the Physical Port Configuration mode, the
To Next Page
Loading...
Need help?
General
