Hirschmann RS20 Reference Manual

CLI Commands: Base
CLI L2P
Release 7.0 05/2011
4.6 Management Commands
95
4.6 Management Commands
These commands manage the switch and show current management
settings.
4.6.1 telnet
This command establishes a new outbound telnet connection to a remote
host. The host value must be a valid IP address. Valid values for port should
be a valid decimal integer in the range of 0 to 65535, where the default value
is 23. If [debug] is used, the current telnet options enabled is displayed. The
optional line parameter sets the outbound telnet operational mode as
‘linemode’, where by default, the operational mode is ‘character mode’. The
echo option enables local echo and only takes effect when the local switch is
accessed via the serial connection (V.24).
Format
telnet <host> <port> [debug] [line] [echo]
Mode
Privileged EXEC and User EXEC

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16