262
4.9
Device Configuration Commands
CLI L2P
Release
7.0
05/2011
4.9.106vlan tagging
This command configures the tagging behavior for a specific interface in a
VLAN to enabled. If tagging is enabled, traffic is transmitted as tagged
frames. If tagging is disabled, traffic is transmitted as untagged frames. The
ID is a valid VLAN identification number.
Format
vlan tagging <1-4042>
Mode
Interface Config
U no vlan tagging
This command configures the tagging behavior for a specific interface in
a VLAN to disabled. If tagging is disabled, traffic is transmitted as
untagged frames. The ID is a valid VLAN identification number.
Format
no vlan tagging <1-4042>
Mode
Interface Config
To Next Page
Loading...
