Hirschmann RS20

CLI L2P
Release 7.0 05/2011
4.9 Device Configuration Commands
181
4.9.13 monitor session <session-id> mode
This command configures the monitor session (port monitoring) mode to en-
able. The probe and monitored ports must be configured before monitor ses-
sion (port monitoring) can be enabled. If enabled, the probe port will monitor
all traffic received and transmitted on the physical monitored port. It is not
necessary to disable port monitoring before modifying the probe and moni-
tored ports.
Default
disabled
Format
monitor session <session-id> mode
Mode
Global Config
session-id
Session number (currently, session number 1 is supported).
U no monitor session <session-id> mode
This command sets the monitor session (port monitoring) mode to
disable.
Format
no monitor session <session-id> mode
Mode
Global Config
session-id
Session number (currently, session number 1 is supported).