Hirschmann RS20

CLI Commands: Security
502
6.1 Security Commands
CLI L2P
Release 7.0 05/2011
6.1.12 dot1x max-users
Use this command to set the maximum number of clients supported on an
interface when MAC-based 802.1X authentication is enabled on the port.
The count value is in the range 1-16 and the default value is 16.
Default
16
Format
dot1x max-users <count>
Mode
Interface Config
U no dot1x max-users
The ‘no’ form of this command resets the maximum number of clients allowed
to its default value of 16.
Format
no dot1x max-users
Mode
Interface Config