Hirschmann RS20 Reference Manual

CLI Commands: Security
516
6.1 Security Commands
CLI L2P
Release 7.0 05/2011
6.1.27 radius server primary
This command is used to configure the primary RADIUS authentication
server for this RADIUS client. The primary server is the one that is used by
default for handling RADIUS requests. The remaining configured servers are
only used if the primary server cannot be reached. A maximum of three
servers can be configured on each client. Only one of these servers can be
configured as the primary. If a primary server is already configured prior to
this command being executed, the server specified by the IP address used
in this command will become the new primary server. The IP address must
match that of a previously configured RADIUS authentication server.
Format
radius server primary <ipaddr>
Mode
Global Config

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16