CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
157
4.6.72 telnetcon timeout
This command sets the telnet connection session timeout value, in minutes.
A session is active as long as the session has not been idle for the value set.
The time is a decimal value from 1 to 160.
Default
5
Format
telnetcon timeout <1-160>
Mode
Privileged EXEC
U no telnetcon timeout
This command sets the telnet connection session timeout value to the
default.
Changing the timeout value for active sessions does not become effec-
tive until the session is reaccessed. Also, any keystroke activates the
new timeout duration.
Format
no telnetcon timeout
Mode
Privileged EXEC
To Next Page
Loading...
