240
4.9
Device Configuration Commands
CLI L2P
Release
7.0
05/2011
4.9.80 snmp trap link-status all
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled
(see “snmp-server enable traps linkmode” ).
Format
snmp trap link-status all
Mode
Global Config
U no snmp trap link-status all
This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled
(see “snmp-server enable traps linkmode”).
Format
no snmp trap link-status all
Mode
Global Config
To Next Page
Loading...
