CLI Commands: Switching
CLI L2P
Release
7.0
05/2011
5.9
Sub-Ring Commands
487
5.9.5 sub-ring <id> port
Specify the switch's ports for the given Sub-Ring ID.
Format
sub-ring <id> port <slot/port>
Mode
Global Config
<id>
Specify the Sub-Ring ID whose settings you want to configure.
<slot/port>
Specify the port (in slot/port) notation.
5.9.6 sub-ring <id> ring-name
Set a ring name for the given Sub-Ring ID.
Format
sub-ring <id> ring-name <ring-name>
Mode
Global Config
<id>
Specify the Sub-Ring ID whose settings you want to configure.
<ring-name>
Enter a name for the given Sub-Ring ID. The name may be up to 254
characters long and contain only printable characters. If you do not
give a name, the current name will be set to an empty string ("").
To Next Page
Loading...
