Hirschmann RS20 - Port-Sec Allowed-Ip

CLI Commands: Switching
CLI L2P
Release 7.0 05/2011
5.6 Port Security
463
U no port-sec
No action is taken if port security is violated at this port.
Format
no port-sec
Mode
Interface Config
5.6.5 port-sec allowed-ip
Enter the allowed IP source address for this port, format: nnn.nnn.nnn.nnn
(nnn: decimal number 0..255) (up to 10).
Format
port-sec allowed-ip <IP Address 1> <IP Address 2>
... <IP Address 10>
Mode
Interface Config
5.6.6 port-sec allowed-ip add
Enter the allowed IP source address for this port, format: nnn.nnn.nnn.nnn
(nnn: decimal number 0..255) (up to 50).
Format
port-sec allowed-ip add <IP Address 1>
<IP Address 2> ... <IP Address 50>
Mode
Interface Config