Name: Hirschmann RS20
Brand: Hirschmann
Rating: 5 (1 reviews)

To Next Page

To Previous Page

CLI Commands: Base

CLI L2P

Release

7.0

05/2011

4.7

Syslog Commands

161

4.7.4 logging console

This command enables logging to the console. The <severitylevel> value is

specified as either an integer from 0 to 7 or symbolically through one of the

following keywords: emergency (0), alert (1), critical (2), error (3), warning

(4), notice (5), informational (6), debug (7).

Default

disabled; alert

Format

logging console [severitylevel] | <[0-7]>

Mode

Global Config

severitylevel | [0-7]

Enter Logging Severity Level (emergency|0, alert|1, critical|2, error|3,

warning|4, notice|5, info|6, debug|7).

Note: selecting a lower severity level (larger number) will include all

messages from higher severity levels (smaller numbers).

Possible severity levels: see Table 15

U no logging console

This command disables logging to the console.

Format

no logging console

Other manuals for Hirschmann RS20

Questions and Answers:

Need help?

Do you have a question about the Hirschmann RS20 and is the answer not in the manual?

General