CLI L2P
Release
7.0
05/2011
4.9
Device Configuration Commands
239
4.9.79 snmp trap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
See ‘snmp-server enable traps linkmode’ command.
Format
snmp trap link-status
Mode
Interface Config
U no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is en-
abled. See ‘snmp-server enable traps linkmode’ command).
Format
no snmp trap link-status
Mode
Interface Config
To Next Page
Loading...
