CLI Commands: Base
82
4.4
Class of Service (CoS) Commands
CLI L2P
Release
7.0
05/2011
4.4 Class of Service (CoS)
Commands
This chapter provides a detailed explanation of the QoS CoS commands.
The following commands are available.
The commands are divided into these different groups:
D Configuration Commands are used to configure features and options of
the switch. For every configuration command there is a show command
that will display the configuration setting.
D Show commands are used to display device settings, statistics and other
information.
Note: The 'Interface Config' mode only affects a single interface, whereas the
'Global Config' mode is applied to all interfaces.
To Next Page
Loading...
