CLI L2P
Release
7.0
05/2011
4.9
Device Configuration Commands
245
4.9.87 storm-control broadcast (port-related)
This command enables the broadcast limiter per port.
Enter the maximum number of broadcasts that the given port is allowed to
send (unit: frames per second, min.: 0 (no limit), default: 0 (no limit)).
Format
storm-control broadcast <max. broadcast rate>
Mode
Interface Config
4.9.88 storm-control egress-limit
Sets the egress rate limit in kbit/s. "0" means: no limit (RS20/RS30/RS40,
MS20/MS30, OCTOPUS only).
Format
storm-control egress-limit <max. egress rate>
Mode
Interface Config
4.9.89 storm-control ingress-limit
Sets the ingress rate limit in kbit/s. "0" means: no limit.
Format
storm-control ingress-limit <max. ingress rate>
Mode
Interface Config
To Next Page
Loading...
