Hirschmann RS20

CLI Commands: Switching
486
5.9 Sub-Ring Commands
CLI L2P
Release 7.0 05/2011
5.9.3 sub-ring <id> operation
Enable or disable the switch for the given Sub-Ring ID.
Format
sub-ring <id> operation {enable|disable}
Mode
Global Config
<id>
Specify the Sub-Ring ID whose settings you want to configure.
enable
Enable the switch for the given Sub-Ring ID.
disable
Disable the switch for the given Sub-Ring ID.
5.9.4 sub-ring <id> protocol
Set MRP or FHR as sub-ring protocol for the given Sub-Ring ID.
Format
sub-ring <id> protocol standard_mrp
Mode
Global Config
<id>
Specify the Sub-Ring ID whose settings you want to configure.
standard_mrp
Set MRP as sub-ring protocol for the given Sub-Ring ID.