CLI Commands: Security
CLI L2P
Release
7.0
05/2011
6.1
Security Commands
511
6.1.21 dot1x unauthenticated-vlan
Use this command to configure the unauthenticated VLAN associated with
the specified interface. The unauthenticated VLAN ID can be a valid VLAN
ID from 0 to maximum supported VLAN ID. The unauthenticated VLAN must
be statically configured in the VLAN database to be operational. By default,
the unauthenticated VLAN is 0, i.e. invalid and not operational.
Default
0
Format
dot1x unauthenticated-vlan <vlan-id>
Mode
Interface Config
<vlan-id>
Enter an existing VLAN ID.
U no dot1x unauthenticated-vlan
The ‘no’ form of this command resets the value for the unauthenticated VLAN
to its default value.
Format
no dot1x unauthenticated-vlan
Mode
Interface Config
To Next Page
Loading...
