CLI Commands: Switching
408
5.1
Spanning Tree Commands
CLI L2P
Release
7.0
05/2011
5.1.10 spanning-tree auto-edgeport
This command specifies that this port is an Edge Port within the common and
internal spanning tree. This will allow this port to transition to Forwarding
State without delay.
Format
spanning-tree auto-edgeport
Mode
Interface Config
U no spanning-tree auto-edgeport
This command specifies that this port is not an Edge Port within the com-
mon and internal spanning tree.
Format
no spanning-tree auto-edgeport
Mode
Interface Config
To Next Page
Loading...
